Need to push or pull air through it? We have experience with high volume
flow, pressure and vacuum control while performing airflow measurements
at the test part. In some cases the air temperatures involved are extreme.
Whether it be a calibration function, endurance test, leak test,
inline or end of line test, we can do it.
Our test machines simulate the final application to determine proper
functionality of the component. Proper production and endurance testing
ensures that only quality and durability goes out the door.
» Engine brake
Front/Rear Axle balancer ↓
show/hide
In-Line, automated front and rear axle balancing machine
This machine is capable of automatically balancing a variety of front or rear axle assemblies in line. Machine vision is used to automatically engage the part, which is presented in a random orientation. Balance is corrected by removing material from the appropriate location on the test part.
» back to top
Hood
hinge set and gauge machine ↓ show/hide
Hood hinge gauging machine
This machine performs a hood hinge "stop" adjustment, closes
the hinge and then and then performs a gauging operation at two points
to verify closing height and angle. The machine performs the operation
on the set of left and right hinges at the same time.
- Manual Operation
- Small footprint
- 100% test guarantees product quality
» back to top
Windshield washer
fluid preheater ↓ show/hide
End of line production tester for windshield washer
fluid heater
This machine is a three station end of line tester for a windshield washer
fluid heater for production vehicles. Many features of the product are
measured such as discharge temperature, seal leakage, current draw, functional
modes, cycle timing and shutdown. Each station can be run simultaneously
without affecting the other. All data is collected and the parts are automatically
marked good where applicable.
» back to top
Modular
test system ↓ show/hide
(view spec sheet - 264k) 
Typical Modular style hydraulic product performance
system
This machine is targeted towards new product development and provides
quick changeover as well as cost efficient conversion to production
in the future. The system is comprised of a hydraulic power unit and
a test station
The concept is that the test station can be configured for a product,
rolled up to the power unit and then performance tested as needed. The
changeover only takes about 15 minutes.
The power unit is capable of delivering two different temperature controlled
fluids to the test station. The test station is fitted for a specific
hydraulic product, but can be changed over easily to other products.
- Provides flexibility and reduces the number of machines required.
- Servo valves control fluid pressures in the test station.
- Large stainless steel sink in test bay leaves plenty of room for
fixturing requirements.
- Scavenge system in test station pumps sink drainage back to power
unit.
- Large access doors on either side of the test bay with double insulated
panes provide excellent accessibility.
- Performance test station can be replaced with production test station
for performing advanced functions.
» back to top
» Steering gear shaft seal endurance
note: to print this page, please click 'show' to expand the information
first
